New Systems From Brentwood Up Into the Canyons
We put in new AC, heat pumps and ductless systems across Brentwood, Mandeville Canyon, Sullivan Canyon, Bel Air, Pacific Palisades, Holmby Hills. The flat streets, the canyon pads and the gated estates each change how a system is sized and set, so each lot gets its own plan.
How the install changes from place to place
Same equipment catalog, different jobs. These are the things that shape a new system in each part of our map before anyone talks about tonnage.
Brentwood
Flat-street ranch houses from the 1950s still breathe through original attic duct. Most replacements here pair the new unit with a resized trunk and return, or the system never reaches its rated airflow.
Mandeville Canyon and Sullivan Canyon
Narrow canyon roads set how equipment arrives, and the condenser usually goes on a pad cut below the house. Line set length and vertical rise get worked out before the estimate. Leaf litter from the tree cover is planned for, too.
Bel Air
Gates and steep lots mean equipment is often staged down the hill and carried up. Screening rules and the estate landscaping usually decide the condenser spot first.
Pacific Palisades
Homes from the bluffs above PCH up toward Topanga State Park get marine-layer mornings and warm inland afternoons. Variable-speed equipment that runs long and steady suits that swing.
Holmby Hills
Large estates between Bel Air and Beverly Hills often split into zones, one per wing or floor. We plan the zone layout and the thermostat for each before the equipment is chosen.
Fire season, everywhere on the map
Santa Ana winds push smoke and ash down every canyon here. A new install is the time to add a deeper filter rack and seal the return so the air really goes through the filter.
Open the install notes for your area
Brentwood and the Westside of Los Angeles
Brentwood
Brentwood splits between flat streets of 1950s ranch homes running their original attic ductwork and canyon estates up Mandeville and Kenter where narrow winding road access decides how equipment arrives and in how many pieces. On the canyon lots the condenser sits on a cut pad below the living space with real vertical rise back to the air handler, while the ranch homes below usually need the supply trunk and return resized before new equipment can reach its rated airflow.
Bel Air and the Santa Monica Mountains foothills
Bel Air
Bel Air estates sit behind private gates on steep canyon lots, so equipment is often staged well below the house and walked up, and the condenser ends up benched into the slope a long way from the air handler. Those distances turn line set sizing and refrigerant charge into a calculated part of the design, while screening requirements and estate landscaping usually settle where the outdoor units can sit before anything else is decided.
Santa Monica and the Westside of Los Angeles
Santa Monica
Santa Monica's beach bungalows and Art Deco apartment buildings were built without ductwork or any mechanical space, so multi zone mini splits with a head in each room and the condenser on a roof or rear pad are the standard retrofit. Lots are tight and neighbors are close, so sound output and setback clearance around the outdoor unit usually decide placement well before line set length does.
Westwood and the central Westside of Los Angeles
Westwood
Westwood's 1920s Spanish houses have plaster walls, tile roofs and nowhere to run a duct chase, so a compact ducted air handler in a borrowed closet or concealed ductless heads beats opening soffits through finished ceilings. The condominium and rental buildings answer to association rules on rooftop and balcony equipment, wall penetrations and permitted work hours, and those rules shape the installation more than the load calculation does.
Next Step
Your lot first, then the equipment.
Call to book a measuring visit anywhere from Brentwood to Holmby Hills. We look at the house, the ducts and the pad, then put the options in writing.
Load
Calculated before the quote
Written
Estimate before work starts